KERMO

DVSA MOT data · 2024 to 2025 · normal MOT tests in Great Britain

Audi Q2 MOT Failure Rate & Common Faults

3% of Q2 cars failed their MOT in 2024 to 2025, which is 16 percentage points below the national average of 19%. Below you can see what fails most, and how the picture changes with the year each car was first registered.

Key figures for the Audi Q2

Fail rate

3%

Pass rate

97%

Tests analysed

150,049

National fail rate

19%

Most common MOT failure reasons for the Q2

Each reason is shown as a share of all Q2 tests in the period, so the percentages add up to more than the fail rate when a car fails for several things at once. Wear and upkeep items are left out of this list: tyres, brake pads and discs, wiper blades, headlamp aim and washer fluid depend on upkeep and driving, so they say little about the model.

  1. Visibility > Washers

    Not working

    Major

    0%of tests

  2. Suspension > Shock absorbers

    Has a serious fluid leak

    Major

    0%of tests

  3. Lamps, reflectors and electrical equipment > Headlamps > Headlamp

    Not working on dipped beam

    Major

    0%of tests

  4. Tyres > Tyre pressure monitoring system

    Malfunctioning or obviously inoperative

    Major

    0%of tests

  5. Brakes > Brake performance > Service brake performance > Rbt > Service brake performance

    Excessively fluctuating

    Major

    0%of tests

Audi Q2 MOT failure rate by year of first registration

Cars first registered in 2022 have the lowest fail rate in this data (1%), and those first registered in 2016 the highest (5%). Years with fewer than 500 tests are left out.

Audi Q2 tests, fail rate and top failure reason by year of first registration
First registeredTestsFail rateTop reason
20161,3605%Lamps, reflectors and electrical equipment > Position lamps > Position lampNot working
201724,1564%Suspension > Shock absorbersHas a serious fluid leak
201828,9664%Suspension > Shock absorbersHas a serious fluid leak
201932,4243%Seat belts and supplementary restraint systems > SRS malfunction indicator lampWarning lamp indicates a fault
202026,6823%Noise, emissions and leaks > Exhaust emissions > Spark ignition > Malfunction indicator lampInoperative or indicates a malfunction
202124,8532%Identification of the vehicle > Registration platesDoes not conform to the specified requirements
202211,2311%Seat belts and supplementary restraint systems > Seat belts > ConditionBuckle not functioning as intended

What to check before you buy a Q2

The areas that fail most often on a Q2 are visibility, suspension and lamps, reflectors and electrical equipment. Ask the seller for the MOT certificates and look at those parts first, on a test drive and on a lift if you can.

Run the registration through our free MOT history check to see past advisories and failures for that specific car. A pattern of the same advisory over several tests tells you more than any model average.

Audi Q2 MOT: quick answers

What percentage of Q2 cars fail their MOT?

3% of 150,049 MOT tests (not retests) on the Audi Q2 failed in 2024 to 2025, according to DVSA data. That is 16 percentage points below the national average of 19%.

What is the most common MOT failure on a Audi Q2?

The most common reason is "Visibility > Washers: Not working", found in 0% of tests.

Is a Audi Q2 reliable?

An MOT fail rate is not the same as a breakdown rate. It counts cars that had at least one defect stopping them passing the test. Use it as one signal next to the car's service history and MOT history, and check the areas listed on this page before you buy.

How to read this data

A fail is not a breakdown. An MOT failure means the car had at least one defect that stops it passing the test, such as worn tyres or a faulty lamp. Many failed cars are still driven safely once the job is fixed, and plenty of cars that pass still break down. This page shows what fails the test, not how reliable the car is on the road.

What is counted. Normal MOT tests (not retests) on cars and light vans in Great Britain, from the DVSA anonymised MOT dataset for 2024 and 2025. A car is tested every year, so one car can appear in several years, and the figures count tests rather than individual cars. A test with a pass after work at the test station (PRS) counts as a pass. Years are the year the car was first registered, so an older car is not automatically a worse one.

Severity. “Dangerous” defects are the most serious category in the MOT manual. “Major” defects mean the car fails but is not an immediate danger. The dangerous share next to each reason shows how often that defect was marked dangerous.

Wear and upkeep items. Tyre defects (tread depth, cuts, bulges), brake pads and discs worn below the limit, wiper blades, headlamp aim and washer fluid are not listed as reasons. A test that failed only for these counts as a pass here, because they depend on upkeep and on how the car is driven. For this model, 7,511 tests failed only for these items and were counted this way.

Limits. The dataset is anonymised, so no individual car is shown. Model names are grouped from DVSA's free-text entries, and some variants and trims are merged, so a single model can cover several versions. Northern Ireland tests are not included.

More Audi MOT failure rates

Compare the Q2 with other Audi models, or browse MOT failure rates for every model.