KERMO

DVSA MOT data · 2024 to 2025 · normal MOT tests in Great Britain

Peugeot 2008 MOT Failure Rate & Common Faults

21% of 2008 cars failed their MOT in 2024 to 2025, which is 2 percentage points above the national average of 19%. Below you can see what fails most, and how the picture changes with the year each car was first registered.

Key figures for the Peugeot 2008

Fail rate

21%

Pass rate

79%

Tests analysed

193,661

National fail rate

19%

Most common MOT failure reasons for the 2008

Each reason is shown as a share of all 2008 tests in the period, so the percentages add up to more than the fail rate when a car fails for several things at once. Wear and upkeep items are left out of this list: tyres, brake pads and discs, wiper blades, headlamp aim and washer fluid depend on upkeep and driving, so they say little about the model.

  1. Body, chassis, structure > Transmission > Drive shafts > Joints

    Constant velocity boot split or insecure, no longer prevents the ingress of dirt

    Major

    8%of tests

  2. Lamps, reflectors and electrical equipment > Registration plate lamp(s)

    Inoperative in the case of a single lamp or all lamps

    Major

    3%of tests

  3. Lamps, reflectors and electrical equipment > Headlamps > Headlamp

    Not working on dipped beam

    Major

    3%of tests

  4. Suspension > Suspension arms > Ball joint

    Ball joint excessively worn

    Major

    2%of tests

  5. Body, chassis, structure > Exhaust system

    System insecure

    Major

    1%of tests

Peugeot 2008 MOT failure rate by year of first registration

Cars first registered in 2019 have the lowest fail rate in this data (10%), and those first registered in 2013 the highest (31%). Years with fewer than 500 tests are left out.

Peugeot 2008 tests, fail rate and top failure reason by year of first registration
First registeredTestsFail rateTop reason
20136,65631%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt
201430,62529%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt
201533,67626%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt
201636,34522%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt
201733,06918%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt
201832,01314%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt
201920,62410%Body, chassis, structure > Transmission > Drive shafts > JointsConstant velocity boot split or insecure, no longer prevents the ingress of dirt

What to check before you buy a 2008

The areas that fail most often on a 2008 are body, chassis, structure, lamps, reflectors and electrical equipment and suspension. Ask the seller for the MOT certificates and look at those parts first, on a test drive and on a lift if you can.

Run the registration through our free MOT history check to see past advisories and failures for that specific car. A pattern of the same advisory over several tests tells you more than any model average.

Peugeot 2008 MOT: quick answers

What percentage of 2008 cars fail their MOT?

21% of 193,661 MOT tests (not retests) on the Peugeot 2008 failed in 2024 to 2025, according to DVSA data. That is 2 percentage points above the national average of 19%.

What is the most common MOT failure on a Peugeot 2008?

The most common reason is "Body, chassis, structure > Transmission > Drive shafts > Joints: Constant velocity boot split or insecure, no longer prevents the ingress of dirt", found in 8% of tests.

Is a Peugeot 2008 reliable?

An MOT fail rate is not the same as a breakdown rate. It counts cars that had at least one defect stopping them passing the test. Use it as one signal next to the car's service history and MOT history, and check the areas listed on this page before you buy.

How to read this data

A fail is not a breakdown. An MOT failure means the car had at least one defect that stops it passing the test, such as worn tyres or a faulty lamp. Many failed cars are still driven safely once the job is fixed, and plenty of cars that pass still break down. This page shows what fails the test, not how reliable the car is on the road.

What is counted. Normal MOT tests (not retests) on cars and light vans in Great Britain, from the DVSA anonymised MOT dataset for 2024 and 2025. A car is tested every year, so one car can appear in several years, and the figures count tests rather than individual cars. A test with a pass after work at the test station (PRS) counts as a pass. Years are the year the car was first registered, so an older car is not automatically a worse one.

Severity. “Dangerous” defects are the most serious category in the MOT manual. “Major” defects mean the car fails but is not an immediate danger. The dangerous share next to each reason shows how often that defect was marked dangerous.

Wear and upkeep items. Tyre defects (tread depth, cuts, bulges), brake pads and discs worn below the limit, wiper blades, headlamp aim and washer fluid are not listed as reasons. A test that failed only for these counts as a pass here, because they depend on upkeep and on how the car is driven. For this model, 6,702 tests failed only for these items and were counted this way.

Limits. The dataset is anonymised, so no individual car is shown. Model names are grouped from DVSA's free-text entries, and some variants and trims are merged, so a single model can cover several versions. Northern Ireland tests are not included.

More Peugeot MOT failure rates

Compare the 2008 with other Peugeot models, or browse MOT failure rates for every model.